Clod Patry: adding header

2012-06-18T14:07:36Z

adding header

Clod Patry: create the page C (for 2.7)

2012-06-15T18:15:11Z

create the page C (for 2.7)

New page

To enable passthrough, follow these steps:
<pre>
1. Make sure "Enable Fax/Modem Relay" is enabled.
2. Make sure "Detection Mode" is Standard.
3. Make sure "Relay Mode" is Passthrough.
4. Make sure "Enable switching to FAX relay upon CNG tone" is checked.
5. Make sure "Detection type" is "Silence Suppression off"
6. Make sure the Codec is the same as the remote end.
</pre>

[[Image:profile_passthru_silence_v27.png]]

← Older revision		Revision as of 14:07, 18 June 2012
Line 1:		Line 1:
		+	=== '''''Applies to version(s): v2.7.''''' ===
		+	{{DISPLAYTITLE:Configure Fax Passthrough}}
		+
	To enable passthrough, follow these steps:		To enable passthrough, follow these steps:
	<pre>		<pre>

Configure Fax Passthrough C - Revision history

Clod Patry: adding header

Clod Patry: create the page C (for 2.7)