Configure Fax Passthrough D - Revision history

Allyntree at 15:52, 7 October 2014

2014-10-07T15:52:33Z

Allyntree: new 2.8 article

2014-10-07T15:52:21Z

new 2.8 article

Allyntree: new 2.8 article

2014-10-07T15:38:18Z

new 2.8 article

New page

=== '''''Applies to version(s): v2.8.''''' ===
{{DISPLAYTITLE:Configure Fax Passthrough}}

'''To enable passthrough:'''

1. Select '''Profiles''' from the navigation menu.

[[Image:ConfigureFaxPassthrough_0.png]]

2. Set '''Detection Mode''' to Standard.

3. Set '''Relay Mode''' to Passthrough.

4. Check the '''Switch to FAX relay upon CNG tone''' option.

5. Set '''Detection type''' to "Silence Suppression off"

6. Verify the the Codec is the same as the remote end.

[[Image:ConfigureFaxPassthrough_1.png]]

← Older revision		Revision as of 15:52, 7 October 2014
Line 10:		Line 10:

	2. Click '''Create New Profile'''		2. Click '''Create New Profile'''
		+
	[[Image:ConfigureFaxPassthrough_1.png]]		[[Image:ConfigureFaxPassthrough_1.png]]

@@ Line 9: / Line 9: @@
-. Set '''Detection Mode''' to Standard.
+. Click '''Create New Profile'''
-. Set '''Relay Mode''' to Passthrough.
+. Enter a name for the Fax Profile.
-. Check the '''Switch to FAX relay upon CNG tone''' option.
+[[Image:ConfigureFaxPassthrough_2.png]]
-. Set '''Detection type''' to "Silence Suppression off"
+. Configure the settings:
-. Verify the the Codec is the same as the remote end.
+[[Image:ConfigureFaxPassthrough_3.png]]
-[[Image:ConfigureFaxPassthrough_1.png]]
+. Verify thet the '''Profile was successfully created''' message is displayed.