Enabling Local NAT Traversal B - Revision history

Allyntree at 19:15, 12 November 2014

2014-11-12T19:15:10Z

Allyntree: 2.8 article

2014-11-12T19:13:40Z

2.8 article

Allyntree: 2.8 article

2014-11-12T19:03:29Z

2.8 article

New page

=== '''''Applies to version: v2.8.''''' ===
{{DISPLAYTITLE:Enabling Local NAT Traversal}}

<br>
To enable Local NAT Traversal:

1- Select '''NATs''' from the navigation panel.

[[Image:EnableLocalNatTraversal_0.png]]

2- Click '''Create New Configuration'''
* Enter a meaningful name.
* Choose a Local Method.
* If necessary, provide an extra parameter.
* Click '''Create'''

[[Image:EnableLocalNatTraversal_1.png]]

Once the NAT configuration is completed, it must be associated with a NAP.

3- Select '''NAPs''' from the navigation panel

[[Image:EnableLocalNatTraversal_2.png]]

4- Select a SIP NAP from the '''Network Access Point''' list

[[Image:EnableLocalNatTraversal_3.png]]

5- In the '''Network Address Translation''' section:
* Choose the desired "Local Method". The select box will contain the same name as the Local NAT configuration, that you provided in step #2.
* Click '''Save'''

[[Image:EnableLocalNatTraversal_4.png]]

The following describes the 2 Local NAT Traversal Methods:'''

'''No NAT'''

This method is used if you are not behind a NAT. This is the default value.

'''Force Public IP'''

This method will set some of the SIP Headers and SDP fields with the IP address that you set.

== Related actions ==
[[Symmetric_NAT_Traversal|Symmetric NAT traversal]]

← Older revision		Revision as of 19:15, 12 November 2014
Line 10:		Line 10:


−	2- Click '''Create New ~~Configuration~~'''	+	2- Click '''Create New NAT Traversal'''

	[[Image:EnableLocalNatTraversal_1.png]]		[[Image:EnableLocalNatTraversal_1.png]]

@@ Line 11: / Line 11: @@
 - Click '''Create New Configuration'''
-* Enter a meaningful name.
 * Choose a Local Method.
 * If necessary, provide an extra parameter.
 * Click '''Create'''
+[[Image:EnableLocalNatTraversal_2.png]]
-[[Image:EnableLocalNatTraversal_1.png]]
-−
 Once the NAT configuration is completed, it must be associated with a NAP.
 - Select '''NAPs''' from the navigation panel
-[[Image:EnableLocalNatTraversal_2.png]]
+[[Image:EnableLocalNatTraversal_3.png]]
 - Select a SIP NAP from the '''Network Access Point''' list
-[[Image:EnableLocalNatTraversal_3.png]]
+[[Image:EnableLocalNatTraversal_4.png]]
@@ Line 37: / Line 40: @@
 * Click '''Save'''
-[[Image:EnableLocalNatTraversal_4.png]]
+[[Image:EnableLocalNatTraversal_5.png]]