Factory Reset - Revision history

Luc Morissette at 21:52, 25 January 2021

2021-01-25T21:52:33Z

Luc Morissette: LM Added details on procedure (trk#19758)

2017-04-04T18:41:31Z

LM Added details on procedure (trk#19758)

Luc Morissette: Updated page

2016-10-27T13:45:24Z

Updated page

Luc Morissette: New page

2016-08-09T20:05:44Z

New page

New page

The Factory reset button is located in a small hole at the right of the shutdown button.
Use a trombone to press the button on the front.
Keep the button pressed until the LEDs become red, then release it. Wait from 2 to 5 minutes to access the system.

@@ Line 5: / Line 5: @@
 The Factory reset function will put the unit in the same state as when it was shipped from [http://www.telcobridges.com TelcoBridges], including the software version. <br>
 After this procedure, there will be no configuration on the unit. The unit will have the default password: Please contact [[TB_Support|Support]] if you do not have this password.  <br>
-You may have to install a new software version on the unit (see [[Toolpack_version_history|Version History]] and [[System_Upgrade|System upgrade]] ).<br>
+You may have to install a new software version on the unit (see [[Tmedia_Version_History|Version History]] and [[System_Upgrade|System upgrade]] ).<br>
 <br>

@@ Line 1: / Line 1: @@
-This function is available on TMG800 units shipped since October 2015 <br>
+=== '''''Applies to version(s): v2.9, v2.10''''' ===
-The Factory reset function will put the unit in the same state as when it was shipped from [http://www.telcobridges.com TelcoBridges]. <br>
+{{DISPLAYTITLE:Factory Reset}}
-After this procedure, you may have to install a new software version on the unit - see [[Toolpack_version_history|Version History]]. <br>
-The Factory reset button is located in a small hole at the right of the shutdown button. Use a trombone to press the button on the front. <br>
+This function is available on '''TMG800''' units shipped since October 2015 <br>
-Keep the button pressed until the LEDs become red, then release it (about 10 seconds). Wait from 2 to 5 minutes to access the system. <br>
+The Factory reset function will put the unit in the same state as when it was shipped from [http://www.telcobridges.com TelcoBridges], including the software version. <br>
 Please follow the [[Product_Installation|installation guide]] for information on how to access the system. <br>

@@ Line 1: / Line 1: @@
-The Factory reset button is located in a small hole at the right of the shutdown button.
+This function is available on TMG800 units shipped since October 2015 <br>
-Use a trombone to press the button on the front.
+The Factory reset function will put the unit in the same state as when it was shipped from [http://www.telcobridges.com TelcoBridges]. <br>
-Keep the button pressed until the LEDs become red, then release it. Wait from 2 to 5 minutes to access the system.
+After this procedure, you may have to install a new software version on the unit - see [[Toolpack_version_history|Version History]]. <br>