MTP2:Signal Unit Error Rate Threshold - Revision history

Ktrueman: cleaned up

2009-09-02T13:44:53Z

cleaned up

Cboulanger at 03:02, 2 September 2009

2009-09-02T03:02:44Z

Ktrueman: correction

2009-08-14T20:30:34Z

correction

Ktrueman: initial content

2009-08-14T20:28:23Z

initial content

New page

The signal unit error rate threshold parameter has as its function the estimation of the signal unit error rate in order to determine the signaling link fault condition.

DESCRIPTION SHOULD BE MORE CLEAR

[[Category:needs revising]]

← Older revision		Revision as of 13:44, 2 September 2009
Line 1:		Line 1:
−	The MTP2 layer is responsible ~~to retransmit~~ missing [[MSU]]s to the remote peer to ensure a valid flow of data. However, when the error rate of ~~[[MSU]]s~~ (the number of errored ~~[[MSU]]s~~ per unit of time) crosses a defined threshold, the link is taken out of service automatically (usually by the upper MTP3 layer). The 'Signal unit error rate threshold' parameter defines this threshold estimate to be monitored by the MTP2 layer before declaring the link as down.	+	The MTP2 layer is responsible for retransmitting missing [[MSU\|MSUs]] to the remote peer to ensure a valid flow of data. However, when the error rate of MSUs (the number of errored MSUs per unit of time) crosses a defined threshold, the link is taken out of service automatically (usually by the upper MTP3 layer).
		+
		+
		+	The '''Signal unit error rate threshold''' parameter defines this threshold estimate to be monitored by the MTP2 layer before declaring the link as down.

@@ Line 1: / Line 1: @@
-The 'Signal unit error rate threshold' parameter has as its function the estimation of the signal unit error rate in order to determine the signaling link fault condition.
+The MTP2 layer is responsible to retransmit missing [[MSU]]s to the remote peer to ensure a valid flow of data.  However, when the error rate of [[MSU]]s (the number of errored [[MSU]]s per unit of time) crosses a defined threshold, the link is  taken out of service automatically (usually by the upper MTP3 layer).   The 'Signal unit error rate threshold' parameter defines this threshold estimate to be monitored by the MTP2 layer before declaring the link as down.
-−
-−
-DESCRIPTION SHOULD BE MORE CLEAR
-−
-[[Category:needs revising]]

← Older revision		Revision as of 20:30, 14 August 2009
Line 1:		Line 1:
−	The ~~signal~~ unit error rate threshold parameter has as its function the estimation of the signal unit error rate in order to determine the signaling link fault condition.	+	The 'Signal unit error rate threshold' parameter has as its function the estimation of the signal unit error rate in order to determine the signaling link fault condition.