Allyntree at 14:47, 26 February 2013

2013-02-26T14:47:28Z

Allyntree: Created page with "The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following: IP Address Netmask *Gateway
== To configure a VoIP0 or VoIP1 port == ..."

2013-02-26T14:45:45Z

Created page with "The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following: *IP Address *Netmask *Gateway == To configure a VoIP0 or VoIP1 port == ..."

New page

The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

*IP Address
*Netmask
*Gateway

 

== To configure a VoIP0 or VoIP1 port ==

1. Select '''IP Interfaces''' from the navigation panel:

[[Image:Toolpack v2.5 Navigation Panel IP Interfaces.png]]

 2. Click '''Edit''' from the IP Interfaces Information panel:

[[Image:Toolpack v2.5 Edit IP Interface.png]]

 3. Configure the IP port:

*Indicate whether or not to use '''DHCP''' on this port
*Enter an '''IP address'''
*Enter a '''Netmask'''
*Enter a '''gateway address'''
*Click '''Save'''

'''Note:''' The IP addresses of ETH0, ETH1, VOIP0 and VOIP1 must be on different subnets. 

[[Image:Toolpack v2.5 Editing IP Interface.png]]

 

4. The changes are displayed in the IP interfaces information panel:

[[Image:Toolpack v2.5 IP Interface Edited.png]]

 '''IMPORTANT!''' The system will display the following notice, describing steps to apply your new configuration:

[[Image:Toolpack v2.5 IP Interface Alert.png]]

 

5. Activate the configuration

Systems -> Edit -> Activate

6. Reboot the adapter (will drop active calls)

Status -> Adapters -> Click on the adapter Serial Number -> Reboot adapter

It will take about 1.5 minutes to restart the unit.

== List of Parameters ==

*[[Parameter: Use DHCP|Use DHCP]]
*[[Parameter: IP Address|IP Address]]
*[[Parameter: Netmask|Netmask]]
*[[Parameter: Gateway|Gateway]]

← Older revision		Revision as of 14:47, 26 February 2013
Line 1:		Line 1:
		+	=== '''''Applies to version(s): v2.5, v2.6.''''' ===
		+	{{DISPLAYTITLE:Configuring VoIP Interfaces}}
		+
	The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:		The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following:

Toolpack:Configuring VoIP Interfaces A - Revision history

Allyntree at 14:47, 26 February 2013

Allyntree: Created page with "The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following: *IP Address *Netmask *Gateway == To configure a VoIP0 or VoIP1 port == ..."

Allyntree: Created page with "The IP interface of the VoIP0 and VoIP1 ports can be configured by setting the following: IP Address Netmask *Gateway
== To configure a VoIP0 or VoIP1 port == ..."