Allyntree: /* List of Parameters */

2015-06-23T15:24:15Z

List of Parameters

Allyntree: New 2.8 article

2014-09-18T15:40:45Z

New 2.8 article

New page

=== '''''Applies to version(s): v2.8.''''' ===
{{DISPLAYTITLE:Creating an M3UA Configuration (IPSP)}}
To set up your M3UA system on an IP server process (IPSP), you must first create a new M3UA configuration.
In this configuration the SS7 MTP2 and MTP3 layers are replaced entirely by the SIGTRAN M3UA layer. This system is typically set up on two IP signaling points.

To create an M3UA configuration on IPSP:

1- Click '''M3UA''' in the navigation panel:

[[Image:CreateM3ua_0.png]]

2- Configure the M3UA service for IPSP:

* Enter a '''name''' for the configuration
* Select '''IP Server Process (IPSP)''' as the node type
* Click '''Create'''

[[Image:CreateM3ua_1.png]]

3- Verify that the '''"M3ua Cfg was successfully created"''' message appears

[[Image:CreateM3ua_2.png]]

==List of Parameters==

* [[Parameter: Name|Name]]
* [[Parameter: Node Type|Node Type]]

← Older revision		Revision as of 15:24, 23 June 2015
Line 30:		Line 30:
	* [[Parameter: Name\|Name]]		* [[Parameter: Name\|Name]]
	* [[Parameter: Node Type\|Node Type]]		* [[Parameter: Node Type\|Node Type]]
		+	<br>
		+	<div class="mw-collapsible mw-collapsed" data-collapsetext="Advanced Parameters" data-expandtext="Advanced Parameters" style="width: 400px;">
		+	{\| class="wikitable"
		+	\|-
		+
		+	* [[Parameter: M3UA: Only one hardware unit is active\|Only one hardware unit is active]]
		+	* [[Parameter: M3UA: Destination Restrict supported\|Destination Restrict supported]]
		+	* [[Parameter: M3UA: Congestion level 1\|Congestion level 1]]
		+	* [[Parameter: M3UA: Congestion level 2\|Congestion level 2]]
		+	* [[Parameter: M3UA: Congestion level 3\|Congestion level 3]]
		+	* [[Parameter: M3UA: Restart Timer\|Restart Timer]]
		+	* [[Parameter: M3UA: MTP3 Status Timer\|MTP3 Status Timer]]
		+	* [[Parameter: M3UA: AS Pending Timer\|AS Pending Timer]]
		+	* [[Parameter: M3UA: Heartbeat Timer\|Heartbeat Timer]]
		+	* [[Parameter: M3UA: ASP Up Timer\|ASP Up Timer]]
		+	* [[Parameter: M3UA: ASP Down Timer\|ASP Down Timer]]
		+	* [[Parameter: M3UA: ASP Messages Timeout\|ASP Messages Timeout]]
		+	* [[Parameter: M3UA: DAUD Timer\|DAUD Timer]]
		+	* [[Parameter: M3UA: DRKM Timer\|DRKM Timer]]
		+	* [[Parameter: M3UA: Number of DKRM messages\|Number of DKRM messages]]
		+	* [[Parameter: M3UA: DUNA Settle Timeout\|DUNA Settle Timeout]]
		+	* [[Parameter: M3UA: Sequence Control Timer\|Sequence Control Timer]]
		+
		+	\|}
		+	</div>

Toolpack:Creating an M3UA Configuration (IPSP) C - Revision history

Allyntree: /* List of Parameters */

Allyntree: New 2.8 article