Allyntree at 13:34, 2 October 2014

2014-10-02T13:34:13Z

Allyntree: new 2.8 article

2014-10-02T13:32:10Z

new 2.8 article

New page

=== '''''Applies to version(s): v2.8.''''' ===
{{DISPLAYTITLE:Creating an M3UA Configuration (SGP)}}
To set up your M3UA system on an IP server process (SGP), you must first create a new M3UA configuration.
In this configuration the SS7 MTP2 layer is replaced entirely by the SIGTRAN M3UA layer, and the MTP3 layer is extended over the IP network.

To create an M3UA configuration on SGP:

1- Click '''M3UA''' in the navigation panel:

[[Image:CreateM3ua_0.png]]

2- Configure the M3UA service for IPSP:

* Enter a '''name''' for the configuration
* Select '''IP Server Process (IPSP)''' as the node type
* Click '''Create'''

[[Image:CreateM3ua_1.png]]

3- Verify that the '''"M3ua Cfg was successfully created"''' message appears

[[Image:CreateM3ua_2.png]]

==List of Parameters==

* [[Parameter: Name|Name]]
* [[Parameter: Node Type|Node Type]]

@@ Line 15: / Line 15: @@
 * Enter a '''name''' for the configuration
-* Select '''IP Server Process (IPSP)''' as the node type
+* Select Signaling Gateway Process (SGP)''' as the node type
 * Click '''Create'''
-[[Image:CreateM3ua_1.png]]
+[[Image:CreateM3ua_SGP_0.png]]

Toolpack:Creating an M3UA Configuration (SGP) C - Revision history

Allyntree at 13:34, 2 October 2014

Allyntree: new 2.8 article