Allyntree: Created page with "=== '''''Applies to version(s): v2.8''''' === {{DISPLAYTITLE:Creating an M3UA SAP}} Once an M3UA configuration is created, you must then create a new M3UA service access point..."

2015-06-23T19:03:40Z

Created page with "=== '''''Applies to version(s): v2.8''''' === {{DISPLAYTITLE:Creating an M3UA SAP}} Once an M3UA configuration is created, you must then create a new M3UA service access point..."

New page

=== '''''Applies to version(s): v2.8''''' ===
{{DISPLAYTITLE:Creating an M3UA SAP}}
Once an M3UA configuration is created, you must then create a new M3UA service access point (SAP) for your system. The SAP is an identifying label for endpoints in your network.

To create an M3UA SAP:

1- Click '''M3UA''' in the navigation panel:

[[Image:CreateM3ua_0.png]]

2- Click '''Create New M3ua Sap''' in the M3UA configuration panel

[[Image:Create_M3UA_SAP_0.png]]

3- Configure the new SAP:

* Enter a '''name''' for the SAP
* Select an '''Unit''' to use
* Select an '''SCTP source port'''
* Click '''Create'''

[[Image:Create_M3UA_SAP_1.png]]

4- Verify that the '''"M3ua Sap was successfully created"''' message appears

[[Image:Create_M3UA_SAP_2.png]]

5- Associate an IP interface with the new SAP:

* Select an available '''IP interface'''
* Click the'''"<<"''' button to associate the interface with the SAP

[[Image:Create_M3UA_SAP_3.png]]

==List of Parameters==

* [[Parameter: Name|Name]]
* [[Parameter: SCTP Adapter|SCTP Adapter]]
* [[Parameter: SCTP Source Port|SCTP Source Port]]

Toolpack:Creating an M3UA SAP C - Revision history

Allyntree: Created page with "=== '''''Applies to version(s): v2.8''''' === {{DISPLAYTITLE:Creating an M3UA SAP}} Once an M3UA configuration is created, you must then create a new M3UA service access point..."