Toolpack:Creating an M3UA User Part (SGP) B - Revision history

Allyntree: /* Advanced Parameters */

2015-06-26T19:04:12Z

Advanced Parameters

Allyntree: /* List of Parameters */

2015-06-26T19:03:00Z

List of Parameters

Allyntree: /* Applies to version(s): v2.8 */

2015-06-26T19:00:51Z

Applies to version(s): v2.8

Allyntree: /* Applies to version(s): v2.8 */

2015-06-26T18:55:30Z

Applies to version(s): v2.8

Allyntree: new 2.8 article

2014-09-22T19:08:53Z

new 2.8 article

New page

=== '''''Applies to version(s): v2.8''''' ===
{{DISPLAYTITLE:Creating an M3UA User Part (SGP)}}
After you create an M3UA network, you must create a new M3UA user part.

To create an M3UA user part:

1- Click '''M3UA''' in the navigation panel:

[[Image:CreateM3ua_0.png]]

2- Select an M3ua Network:

[[Image:SelectM3uaNetwork_A_0.png]]

3- Click '''Create New M3ua Userpart''' in the M3UA network configuration window

[[Image:Create_M3UA_Userpart_0_A.png]]

3- Configure the new M3UA user part:

* For a system set up on a '''Signaling Gateway''', you need to connect this entity to a '''MTP3 network''': Select an '''MTP3 network'''
** Note: the MTP3 network field is only shown for a SGP.
* Click '''Create'''

[[Image:Create_M3UA_Userpart_SGP_1.png]]

4- Verify that the '''"M3ua Userpart was successfully created"''' message appears

[[Image:Create_M3UA_Userpart_2.png]]

==List of Parameters==

* [[Parameter: Name|Name]]

@@ Line 39: / Line 39: @@
-==Advanced Parameters==
+'''Advanced Parameters'''
-−
 * [[Parameter: MTP3 Primitive Timer|MTP3 Primitive Timer]]

← Older revision		Revision as of 19:03, 26 June 2015
Line 37:		Line 37:

	* [[Parameter: Name\|Name]]		* [[Parameter: Name\|Name]]
		+
		+
		+	==Advanced Parameters==
		+
		+	* [[Parameter: MTP3 Primitive Timer\|MTP3 Primitive Timer]]

← Older revision		Revision as of 18:55, 26 June 2015
Line 13:		Line 13:
	2- Select an M3ua Network:		2- Select an M3ua Network:

−	[[Image:~~SelectM3uaNetwork_A_0~~.png]]	+	[[Image:SelectM3uaNetwork_SGP_0.png]]

@@ Line 32: / Line 32: @@
 - Verify that the '''"M3ua Userpart was successfully created"''' message appears
-[[Image:Create_M3UA_Userpart_2.png]]
+[[Image:Create_M3UAUserPart_2_SGP.png]]
 ==List of Parameters==
 * [[Parameter: Name|Name]]