Toolpack:Creating an MTP3 Configuration D - Revision history

Allyntree: /* List of Parameters */ Modified parameter links. Grouped Timers into its own category

2015-09-02T13:54:24Z

List of Parameters: Modified parameter links. Grouped Timers into its own category

Allyntree: /* Applies to version(s): v2.8 */ Revised step 2 and changed its screenshot.

2015-09-02T13:50:25Z

Applies to version(s): v2.8: Revised step 2 and changed its screenshot.

Allyntree: New 2.8 artic;e

2014-09-09T13:47:29Z

New 2.8 artic;e

New page

=== '''''Applies to version(s): v2.8''''' ===
{{DISPLAYTITLE:Creating an MTP3 Configuration}}
Once you have set up the MTP2 layer of your SS7 system, you must create an MTP3 configuration.
[[MTP3_Layer|MTP3]] provides message routing between signaling points in an SS7 network.

To create an MTP3 configuration:

1- Select '''MTP3''' from the navigation panel

[[Image:Mtp3_0_A.png]]

2- Configure the new MTP3 service:

* Enter a '''name''' for the MTP3 configuration
* Make sure the '''Enabled''' and '''SSf Validation''' boxes are checked
* Select '''SP''' as the '''signaling point type'''
* Select a '''restart procedure'''
* Click '''Create'''

[[Image:Mtp3_1_A.png]]

3- Verify that the '''"Mtp3Cfg was successfully created"''' message appears

[[Image:Mtp3_2_A.png]]

==List of Parameters==

* [[Parameter: Name|Name]]
* [[Parameter: Enabled|Enabled]]
* [[Parameter: SSf Validation|SSf Validation]]
* [[Parameter: Signaling Point Type|Signaling Point Type]]
* [[Parameter: MTP3 T15 Timer|T15 Timer]]
* [[Parameter: MTP3 T16 Timer|T16 Timer]]
* [[Parameter: MTP3 T18 Timer|T18 Timer]]
* [[Parameter: MTP3 T19 Timer|T19 Timer]]
* [[Parameter: MTP3 T21 Timer|T21 Timer]]
* [[Parameter: MTP3 T26 Timer|T26 Timer]]

Advanced Parameters
* [[Parameter: MTP3 Ssf Validation|Ssf Validation]]
* [[Parameter: Restart Procedure|Restart Procedure]]
* [[Parameter: MTP3 Transfer Restricted required|Transfer Restricted required]]

@@ Line 24: / Line 24: @@
 ==List of Parameters==
 * [[Parameter: Name|Name]]
 * [[Parameter: Enabled|Enabled]]
 * [[Parameter: Signaling Point Type|Signaling Point Type]]
 * [[Parameter: MTP3 T15 Timer|T15 Timer]]
 * [[Parameter: MTP3 T16 Timer|T16 Timer]]
@@ Line 36: / Line 36: @@
 * [[Parameter: MTP3 T26 Timer|T26 Timer]]
-Advanced Parameters
+'''Advanced Parameters'''
 * [[Parameter: MTP3 Ssf Validation|Ssf Validation]]
 * [[Parameter: MTP3 Transfer Restricted required|Transfer Restricted required]]

@@ Line 15: / Line 15: @@
 * Make sure the '''Enabled''' and '''SSf Validation''' boxes are checked
 * Select '''SP''' as the '''signaling point type'''
 * Click '''Create'''