Toolpack:Creating the M2UA Configuration C - Revision history

Rblanchet: Added m2ua node type

2015-08-24T14:57:15Z

Added m2ua node type

Rblanchet: Added node type

2015-08-24T14:44:38Z

Added node type

Allyntree: New 2.8 article

2014-09-30T17:48:36Z

New 2.8 article

New page

=== '''''Applies to version(s): v2.8.''''' ===
{{DISPLAYTITLE:Creating the M2UA Configuration}}
To create your [[M2UA]] system, you must create a new M2UA configuration.

M2UA (Message Transfer Part 2 User Adaptation Layer) is used to interface the [[MTP2 Layer]] of a signaling gateway to the [[MTP3 Layer]] of a media gateway controller (MGC). M2UA can also be seen as a way to extend an MTP2 link. An M2UA link is always bound to an MTP2 link.

To create an M2UA configuration:

1- Click '''M2UA''' in the navigation panel

[[Image:Create_M2ua_0.png]]

2- Create the M2UA configuration:

* Enter a '''name''' for the M2UA service
* Click '''Create'''

[[Image:Create_M2ua_1.png]]

3- Verify that the '''"M2ua Cfg was successfully created"''' message appears

[[Image:Create_M2ua_2.png]]

==List of Parameters==

* [[Parameter: Name|Name]]

← Older revision		Revision as of 14:57, 24 August 2015
Line 27:		Line 27:

	* [[Parameter: Name\|Name]]		* [[Parameter: Name\|Name]]
		+	* [[Parameter: M2UA Node Type\|M2UA Node Type]]

@@ Line 15: / Line 15: @@
 * Enter a '''name''' for the M2UA service
 * Click '''Create'''
@@ Line 22: / Line 23: @@
 [[Image:Create_M2ua_2.png]]
 ==List of Parameters==
 * [[Parameter: Name|Name]]