Toolpack:Reset NetworkDevice A - Revision history

Allyntree at 19:45, 10 December 2020

2020-12-10T19:45:54Z

Luc Morissette at 16:58, 31 July 2019

2019-07-31T16:58:04Z

Luc Morissette at 16:57, 31 July 2019

2019-07-31T16:57:29Z

Luc Morissette: Added Change Network Devices Roles

2019-07-31T16:57:07Z

Added Change Network Devices Roles

New page

=== '''''Applies to version(s) v3.0, v3.1''''' ===
{{DISPLAYTITLE:Resetting the Network Device Role}}

Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces.
To do so you must reset the network device role settings of the unit.
'''Note: this will reallocate the main network controller and stop the service for a few minutes'''

'''To reset the network device role, do the following:'''

1- Click '''Hosts''' in the navigation panel.

[[Image:HostRoleReset_0_A.png]]

2- Select the serial number of the unit.

[[Image:HostRoleReset_1_A.png]]

3- Click the '''Status''' tab.

[[Image:HostRoleReset_2_A.png]]

4- In the Action drop down box select '''Change Network Devices Roles'''
* Click '''Apply Action'''
[[Image:Host_action_snapshot_network.png]]
After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: [[TSBC-SW:WebPortal:Initial_Configuration|Initial Configuration]], Step 8

← Older revision		Revision as of 19:45, 10 December 2020
Line 1:		Line 1:
−	~~=== '''''Applies to version(s) v3.0, v3.1''''' ===~~
	{{DISPLAYTITLE:Resetting the Network Device Role}}		{{DISPLAYTITLE:Resetting the Network Device Role}}
		+	{\| class="wikitable"
		+	\|-
		+	\|rowspan="3"\|This article applies to:
		+	\|'''Product'''
		+	\|'''Version'''
		+	\|-
		+	\|SBC
		+	\|3.0, 3.1
		+	\|}

	Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces.		Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces.

@@ Line 26: / Line 26: @@
 * Click '''Apply Action'''
 [[Image:Host_action_snapshot_network.png]]
 After a few seconds, refresh the web interface and you will be brought back to the selection of network interfaces: [[TSBC-SW:WebPortal:Initial_Configuration|Initial Configuration]], Step 8

@@ Line 3: / Line 3: @@
 Once the FreeSBC/ProSBC is configured, it is possible add or change physical IP interfaces.
-To do so you must reset the network device role settings of the unit.
+To do so you must reset the network device role settings of the unit. <br>
 '''Note: this will reallocate the main network controller and stop the service for a few minutes'''