Toolpack:Creating an SCCP Network A
From TBwiki
(Difference between revisions)
| Line 17: | Line 17: | ||
* Provide a [[Parameter: Name|Name]] for the SCCP network | * Provide a [[Parameter: Name|Name]] for the SCCP network | ||
* Select an [[Parameter: MTP3 Network|MTP3 Network]] on which to bind the SCCP stack | * Select an [[Parameter: MTP3 Network|MTP3 Network]] on which to bind the SCCP stack | ||
| + | * Select an [[Parameter: Protocol Type|SCCP Protocol Variant]] | ||
| + | * Select an [[Parameter: SCCP Net Indicator Bit|SCCP Net Indicator Bit]] | ||
| + | * Select an [[Parameter: Point Code|Self Point Code]] | ||
* Click '''Create''' | * Click '''Create''' | ||
Revision as of 08:16, 9 May 2012
Now that you have created the initial SCCP stack, you must create a new SCCP network for your system.
The SCCP network tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3. Based upon your system configuration, one or more SCCP networks are created. Repeat this section for as many networks as you require.
To create an SCCP network:
1- Click Create New SCCP Network in the SCCP stack configuration window
2- Configure the new SCCP network:
- Provide a Name for the SCCP network
- Select an MTP3 Network on which to bind the SCCP stack
- Select an SCCP Protocol Variant
- Select an SCCP Net Indicator Bit
- Select an Self Point Code
- Click Create
3- Verify that the "SCCP Network was successfully created" message appears
