Toolpack:Creating an SCCP Route A

Revision as of 11:31, 11 May 2012

Now that you have created an SCCP LSAP, you must create a new SCCP route for your system. This step in the Web Portal configuration exists to create a route to a specific destination point code (DPC).

To Create an SCCP Route:

1- Click Create new Sccp Route in the SCCP LSAP configuration window

2- Configure the new SCCP Route:

• Choose a Name for the new route
• Select a Protocol Variant
• Select a Replication Mode (ANSI96 and TELCORDIA variants)
• Select an SLS Mask (ANSI and TELCORDIA protocol variants)
• Select a Destination Point Code for this route
• Click Create

3- Verify that the "SccpRoute was successfully created" message appears

4- Configure SCCP Route Backup Point Code

• Assign Backup Point Codes to use in case this route's DPC is not available.

• Note: For each selected point codes, a valid SCCP route must be exist.

List of Parameters

• Name
• Protocol Variant
• Replication Mode
• SLS Mask (For ANSI and TELCORDIA variants only)
• Destination Point Code

Navigation