Configure Fax Passthrough NSE A
From TBwiki
(Difference between revisions)
Clod Patry (Talk | contribs) (remove the condition with CNG for NSE) |
Clod Patry (Talk | contribs) (adding header) |
||
| (One intermediate revision by one user not shown) | |||
| Line 1: | Line 1: | ||
| + | === '''''Applies to version(s): v2.7.''''' === | ||
| + | {{DISPLAYTITLE:Configure Fax Passthrough NSE}} | ||
| + | |||
To enable passthrough with NSE, follow these steps: | To enable passthrough with NSE, follow these steps: | ||
<pre> | <pre> | ||
| Line 8: | Line 11: | ||
6. Make sure "Use NSE" is checked. By unchecking this option, you will switch to Fax Passthrough using SIP re-INVITE. | 6. Make sure "Use NSE" is checked. By unchecking this option, you will switch to Fax Passthrough using SIP re-INVITE. | ||
</pre> | </pre> | ||
| + | |||
| + | |||
| + | [[Image:profile_nse_v27.png]] | ||
Latest revision as of 09:06, 18 June 2012
Applies to version(s): v2.7.
To enable passthrough with NSE, follow these steps:
1. Make sure "Enable Fax/Modem Relay" is enabled. 2. Make sure "Detection Mode" is Standard. 3. Make sure "Relay Mode" is Passthrough. 4. Make sure "Detection type" is "Silence Suppression off" 5. Make sure the Codec is the same as the remote end. 6. Make sure "Use NSE" is checked. By unchecking this option, you will switch to Fax Passthrough using SIP re-INVITE.
