Toolpack:Creating the SCTP Configuration A
From TBwiki
(Difference between revisions)
(Created page with 'Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages. To edit your system's SCTP configuration: 1- Sele…') |
|||
| (8 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| + | === '''''Applies to version(s): v2.5, v2.6.''''' === | ||
| + | {{DISPLAYTITLE:Creating the SCTP Configuration}} | ||
Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages. | Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages. | ||
| Line 9: | Line 11: | ||
2- Configure the SCTP service | 2- Configure the SCTP service | ||
| + | * Make sure the box labeled '''Enabled''' is '''checked''' | ||
* Enter a '''name''' for the SCTP service | * Enter a '''name''' for the SCTP service | ||
* Select an appropriate '''service type''': | * Select an appropriate '''service type''': | ||
| − | ** [[RAW IP]] | + | ** [[RAW IP|RAW_IP]] |
| − | ** [[UDP IP]] | + | ** [[UDP IP|UDP]] |
| − | * Click ''' | + | * Click '''Create''' |
| − | [[Image:Toolpack_v2. | + | [[Image:Toolpack_v2.5_Creating_SCTP.png]] |
| − | 3- Verify that the '''Sctp Cfg was successfully | + | 3- Verify that the '''"Sctp Cfg was successfully created"''' message appears |
| − | [[Image:Toolpack_v2. | + | [[Image:Toolpack_v2.5_SCTP_Created.png]] |
| + | |||
| + | |||
| + | ==List of Parameter== | ||
| + | |||
| + | * [[Parameter: Name|Name]] | ||
| + | * [[Parameter: Service Type|Service Type]] | ||
Latest revision as of 14:42, 9 July 2012
Applies to version(s): v2.5, v2.6.
Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages.
To edit your system's SCTP configuration:
1- Select SCTP from the navigation panel
2- Configure the SCTP service
- Make sure the box labeled Enabled is checked
- Enter a name for the SCTP service
- Select an appropriate service type:
- Click Create
3- Verify that the "Sctp Cfg was successfully created" message appears
