Toolpack:Modifying ISUP Userpart for SPIROU A
From TBwiki
(Difference between revisions)
(Adding title to the page) |
(Added configuration of T6 timer) |
||
| Line 16: | Line 16: | ||
*[[Toolpack:Enabling_strict_SPIROU_validation A|Enabling strict SPIROU validation]] | *[[Toolpack:Enabling_strict_SPIROU_validation A|Enabling strict SPIROU validation]] | ||
| − | 6- Click | + | 6- Click '''Timers''' to expand the Timers section |
| − | 7- Verify that the '''"IsupUserpart was successfully updated"''' message is displayed | + | 7- Set '''T6 Timer''' between 60000 and 120000 ms (between 60 and 120 seconds) |
| + | |||
| + | 8- Click the '''Save''' button | ||
| + | |||
| + | 9- Verify that the '''"IsupUserpart was successfully updated"''' message is displayed | ||
Revision as of 09:34, 14 December 2012
Applies to version(s): v2.6, v2.7.
This section assumes:
- SS7 ISUP is already configured
1- Select SS7-->ISUP from the navigation panel
2- Click on the Edit button for the ISUP stack you want to configure
3- In the Editing Userparts section, click on the ISUP userpart you want to configure
4- Select SPIROU in the Protocol Variant drop-down menu
5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.
6- Click Timers to expand the Timers section
7- Set T6 Timer between 60000 and 120000 ms (between 60 and 120 seconds)
8- Click the Save button
9- Verify that the "IsupUserpart was successfully updated" message is displayed
