Configure Fax Passthrough A
From TBwiki
(Difference between revisions)
(fix content between v2.6 and v2.7) |
(add v2.7) |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): v2.6.''''' === | + | === '''''Applies to version(s): v2.6, v2.7.''''' === |
{{DISPLAYTITLE:Configure Fax Passthrough}} | {{DISPLAYTITLE:Configure Fax Passthrough}} | ||
Revision as of 10:54, 17 July 2013
Applies to version(s): v2.6, v2.7.
To enable passthrough, follow these steps:
1. Make sure "Enable Fax/Modem Relay" is enabled. 2. Make sure "Detection Mode" is Standard. 3. Make sure "Relay Mode" is Passthrough. 4. Make sure "Enable switching to FAX relay upon CNG tone" is checked. 5. Make sure "Detection type" is "Silence Suppression off" 6. Make sure the Codec is the same as the remote end.
