Configure Fax Passthrough A

From TBwiki

(Difference between revisions)

Latest revision as of 10:09, 22 July 2013

To enable passthrough:

1. Select Profiles from the navigation menu.

2. Set Detection Mode to Standard.

3. Set Relay Mode to Passthrough.

4. Check the Switch to FAX relay upon CNG tone option.

5. Set Detection type to "Silence Suppression off"

6. Verify the the Codec is the same as the remote end.

@@ Line 1: / Line 1: @@
-=== '''''Applies to version(s): v2.6.''''' ===
+=== '''''Applies to version(s): v2.6, v2.7.''''' ===
 {{DISPLAYTITLE:Configure Fax Passthrough}}
-To enable passthrough, follow these steps:
+'''To enable passthrough:'''
-<pre>
-. Make sure "Enable Fax/Modem Relay" is enabled.
+. Select '''Profiles''' from the navigation menu.
-. Make sure "Detection Mode" is Standard.
-. Make sure "Relay Mode" is Passthrough.
+[[Image:Profiles_0.png]]
-. Make sure "Enable switching to FAX relay upon CNG tone" is checked.
-. Make sure "Detection type" is "Silence Suppression off"
-. Make sure the Codec is the same as the remote end.
+. Set '''Detection Mode''' to Standard.
-</pre>
+. Set '''Relay Mode''' to Passthrough.
+. Check the '''Switch to FAX relay upon CNG tone''' option.
+. Set '''Detection type''' to "Silence Suppression off"
+. Verify the the Codec is the same as the remote end.
 [[Image:Profile_passthru_silence_v26.png]]