Toolpack:Modifying ISUP Stack for SPIROU A
From TBwiki
(Difference between revisions)
(First version of the page to configure ISUP stack for SPIROU) |
(Changed numbering scheme) |
||
| (One intermediate revision by one user not shown) | |||
| Line 13: | Line 13: | ||
2- Click on the '''Edit''' button for the ISUP stack you want to configure | 2- Click on the '''Edit''' button for the ISUP stack you want to configure | ||
| − | + | 3- Expand the '''Advanced Parameters''' section and check the following parameters | |
* '''No confusion''' must be chosen | * '''No confusion''' must be chosen | ||
| − | + | 4- Click the '''Save''' button | |
| − | + | 5- Verify that the '''"IsupStack was successfully updated"''' message is displayed | |
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Isup Stack Options|Isup Stack Options]] | ||
Latest revision as of 08:02, 7 January 2014
Applies to version(s): v2.6, v2.7.
This section assumes:
- SS7 ISUP is already configured
Note that if you want to eventually validate SPIROU configuration, you will need to repeat these steps for all the ISUP stacks in your current configuration..
1- Select SS7-->ISUP from the navigation panel
2- Click on the Edit button for the ISUP stack you want to configure
3- Expand the Advanced Parameters section and check the following parameters
- No confusion must be chosen
4- Click the Save button
5- Verify that the "IsupStack was successfully updated" message is displayed
