Toolpack:Modifying ISUP Userpart for SPIROU A
From TBwiki
(Difference between revisions)
(Adding title to the page) |
(→Applies to version(s): v2.6, v2.7.) |
||
| (2 intermediate revisions by one user not shown) | |||
| Line 14: | Line 14: | ||
5- A new checkbox '''Strict SPIROU validation''' appears once SPIROU Protocol Variant is selected. | 5- A new checkbox '''Strict SPIROU validation''' appears once SPIROU Protocol Variant is selected. | ||
| − | * | + | *Check this new checkbox to make sure your configuraton is compliant with SPIROU. |
| + | |||
| + | 6- Click '''Timers''' to expand the Timers section | ||
| − | + | 7- Set '''T6 Timer''' between 60000 and 120000 ms (between 60 and 120 seconds) | |
| − | + | 8- Click '''Advanced Parameters''' to expand the Advanced Parameters section | |
| + | |||
| + | 9- Uncheck the '''Allow group messages''' option | ||
| + | |||
| + | 10- Click the '''Save''' button | ||
| + | |||
| + | 11- Verify that the '''"IsupUserpart was successfully updated"''' message is displayed | ||
| + | |||
| + | ==List of Parameters== | ||
| + | |||
| + | * [[Parameter: Protocol Type|Protocol Variant]] | ||
| + | * [[Toolpack:Enabling_strict_SPIROU_validation A|Strict SPIROU validation]] | ||
| + | * [[Parameter: Isup Userpart Timers|Timers]] | ||
Latest revision as of 08:57, 16 January 2014
Applies to version(s): v2.6, v2.7.
This section assumes:
- SS7 ISUP is already configured
1- Select SS7-->ISUP from the navigation panel
2- Click on the Edit button for the ISUP stack you want to configure
3- In the Editing Userparts section, click on the ISUP userpart you want to configure
4- Select SPIROU in the Protocol Variant drop-down menu
5- A new checkbox Strict SPIROU validation appears once SPIROU Protocol Variant is selected.
- Check this new checkbox to make sure your configuraton is compliant with SPIROU.
6- Click Timers to expand the Timers section
7- Set T6 Timer between 60000 and 120000 ms (between 60 and 120 seconds)
8- Click Advanced Parameters to expand the Advanced Parameters section
9- Uncheck the Allow group messages option
10- Click the Save button
11- Verify that the "IsupUserpart was successfully updated" message is displayed
