Toolpack:Creating MTP2 Links B
From TBwiki
(Difference between revisions)
(→List of Parameters) |
m (→Applies to version(s): v2.8) |
||
| Line 25: | Line 25: | ||
* Select a '''[[DPC]] length''' | * Select a '''[[DPC]] length''' | ||
* Select a '''timeslot rate''' | * Select a '''timeslot rate''' | ||
| + | * Select the type of '''Error Correction''' to use. | ||
| + | |||
* Click '''Create''' | * Click '''Create''' | ||
| Line 33: | Line 35: | ||
[[Image:Create_MTP2_Link_2.png]] | [[Image:Create_MTP2_Link_2.png]] | ||
| − | |||
==List of Parameters== | ==List of Parameters== | ||
Revision as of 08:43, 9 September 2014
Applies to version(s): v2.8
Once you have created an MTP2 configuration, you must create the necessary MTP2 links. An MTP2 link is used to connect the MTP2 physical layer to a line service carrying SS7 signaling.
To create an MTP2 link:
1- Click MTP2 in the Navigation panel.
2- Click Create New Mtp2 Link in the MTP2 configuration window
3- Configure the new MTP2 link:
- Enter a name for the new link
- Select a connection mode
- Select a line service
- Assign timeslots to the link
- Select a protocol type
- Select a DPC length
- Select a timeslot rate
- Select the type of Error Correction to use.
- Click Create
4- Verify that the "MTP2 link was successfully created" message appears
