Toolpack:Creating the M2PA Configuration c
From TBwiki
(Difference between revisions)
(New 2.8 article) |
(→Applies to version(s): v2.8.) |
||
| (4 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.8.''''' === | === '''''Applies to version(s): v2.8.''''' === | ||
{{DISPLAYTITLE:Creating the M2PA Configuration}} | {{DISPLAYTITLE:Creating the M2PA Configuration}} | ||
| − | + | ||
| − | To | + | To create an M2PA configuration: |
| − | 1- Select ''' | + | 1- Select '''M2PA''' from the navigation panel |
[[Image:CreateM2pa_0.png]] | [[Image:CreateM2pa_0.png]] | ||
| − | 2- Configure the | + | |
| + | 2- Configure the M2PA service | ||
* Make sure the box labelled '''Enabled''' is '''checked''' | * Make sure the box labelled '''Enabled''' is '''checked''' | ||
| − | * Enter a '''name''' for the | + | * Enter a '''name''' for the M2PA service |
| − | + | ||
| − | + | ||
| − | + | ||
* Click '''Create''' | * Click '''Create''' | ||
[[Image:CreateM2pa_1.png]] | [[Image:CreateM2pa_1.png]] | ||
| − | |||
| − | + | 3- Verify that the '''"M2pa Cfg was successfully created"''' message appears | |
| + | [[Image:CreateM2pa_2.png]] | ||
==List of Parameter== | ==List of Parameter== | ||
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
| − | |||
Latest revision as of 09:46, 18 September 2014
Applies to version(s): v2.8.
To create an M2PA configuration:
1- Select M2PA from the navigation panel
2- Configure the M2PA service
- Make sure the box labelled Enabled is checked
- Enter a name for the M2PA service
- Click Create
3- Verify that the "M2pa Cfg was successfully created" message appears
