Toolpack:Creating the M2PA Configuration c
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.8.) |
(→Applies to version(s): v2.8.) |
||
| (3 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.8.''''' === | === '''''Applies to version(s): v2.8.''''' === | ||
{{DISPLAYTITLE:Creating the M2PA Configuration}} | {{DISPLAYTITLE:Creating the M2PA Configuration}} | ||
| − | + | ||
| − | To | + | To create an M2PA configuration: |
| − | 1- Select ''' | + | 1- Select '''M2PA''' from the navigation panel |
[[Image:CreateM2pa_0.png]] | [[Image:CreateM2pa_0.png]] | ||
| − | 2- Configure the | + | 2- Configure the M2PA service |
* Make sure the box labelled '''Enabled''' is '''checked''' | * Make sure the box labelled '''Enabled''' is '''checked''' | ||
| − | * Enter a '''name''' for the | + | * Enter a '''name''' for the M2PA service |
* Click '''Create''' | * Click '''Create''' | ||
| Line 26: | Line 26: | ||
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
| − | |||
Latest revision as of 09:46, 18 September 2014
Applies to version(s): v2.8.
To create an M2PA configuration:
1- Select M2PA from the navigation panel
2- Configure the M2PA service
- Make sure the box labelled Enabled is checked
- Enter a name for the M2PA service
- Click Create
3- Verify that the "M2pa Cfg was successfully created" message appears
