Toolpack:Creating an M2PA SAP C
From TBwiki
(Difference between revisions)
(New 2.8 article) |
(→Applies to version(s): v2.8.) |
||
| (3 intermediate revisions by one user not shown) | |||
| Line 10: | Line 10: | ||
[[Image:CreateM2pa_0.png]] | [[Image:CreateM2pa_0.png]] | ||
| − | 2- Click '''Create new | + | |
| + | 2- Click '''Create new M2PA Sap''' | ||
[[Image:CreateM2paSap_0.png]] | [[Image:CreateM2paSap_0.png]] | ||
| Line 26: | Line 27: | ||
4- Verify that the '''"M2pa Sap was successfully created"''' message appears | 4- Verify that the '''"M2pa Sap was successfully created"''' message appears | ||
| − | [[Image: | + | [[Image:CreateM2paSap_2a.png]] |
| Line 34: | Line 35: | ||
* Click the '''"<<"''' button to add the selected IP interface. This is the outgoing route from the hardware adapter. | * Click the '''"<<"''' button to add the selected IP interface. This is the outgoing route from the hardware adapter. | ||
| − | [[Image:CreateM2paSap_3.png]] | + | '''Before''' [[Image:CreateM2paSap_3.png]] |
| + | '''After''' [[Image:CreateM2paSap_4.png]] | ||
==List of Parameters== | ==List of Parameters== | ||
Latest revision as of 11:09, 18 September 2014
Applies to version(s): v2.8.
After you create an M2PA configuration, you must create a new M2PA service access point (SAP), which functions as the identifying label for endpoints in your network.
To create a new M2PA SAP:
1- Select M2PA from the navigation panel
2- Click Create new M2PA Sap
3- Configure the new M2PA SAP:
- Enter a name for the SAP
- Enter an SCTP source port for the SAP
- Click Create
4- Verify that the "M2pa Sap was successfully created" message appears
5- Associate IP interfaces
- Select an IP interface from the list in the information panel
- Click the "<<" button to add the selected IP interface. This is the outgoing route from the hardware adapter.
Before 
After 
