Toolpack:Creating an M2PA SAP C
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.8.) |
(→Applies to version(s): v2.8.) |
||
| Line 11: | Line 11: | ||
| − | 2- Click '''Create new | + | 2- Click '''Create new M2PA Sap''' |
[[Image:CreateM2paSap_0.png]] | [[Image:CreateM2paSap_0.png]] | ||
Latest revision as of 11:09, 18 September 2014
Applies to version(s): v2.8.
After you create an M2PA configuration, you must create a new M2PA service access point (SAP), which functions as the identifying label for endpoints in your network.
To create a new M2PA SAP:
1- Select M2PA from the navigation panel
2- Click Create new M2PA Sap
3- Configure the new M2PA SAP:
- Enter a name for the SAP
- Enter an SCTP source port for the SAP
- Click Create
4- Verify that the "M2pa Sap was successfully created" message appears
5- Associate IP interfaces
- Select an IP interface from the list in the information panel
- Click the "<<" button to add the selected IP interface. This is the outgoing route from the hardware adapter.
Before 
After 
