Toolpack:Adding M2PA Links B

Revision as of 10:22, 18 September 2014

Applies to version(s): v2.8

AFter you create an M2PA service access point (SAP), you must create a new M2PA link. This can be done from the M2PA SAP configuration window. To create an M2PA link:

1- Click Create new M2pa link in the M2PA SAP configuration window:

2- Click Create new M2pa link in the M2PA SAP configuration window:

3- Click Create new M2pa link in the M2PA SAP configuration window:

4- Configure the new link:

• Enter a name for the link
• Select a protocol type:
  • ITU
  • ANSI
  • TTC
• Set other features, as needed:
  • Number of SCTP Streams
  • IP Header TOS
  • Destination port (same value as the one configured on the destination side)
• Click Create

5- Enter a destination address in the appropriate box in the information panel:

• Click the "<<" button to add the destination address to the address list

6- Verify that the address has been added to the list, and that the "(your address) was successfully added" message appears (ex.: here the address is 190.0.0.0)

List of Parameters

• Name
• Protocol Type
• Number of SCTP Streams
• IP Header TOS
• Destination Port