TMG:Change Internal Subnets Procedure
| Line 6: | Line 6: | ||
'''Note''': If your Unit was just shipped, it does not yet has it's "role" configured, and you can skip to step 2 below. | '''Note''': If your Unit was just shipped, it does not yet has it's "role" configured, and you can skip to step 2 below. | ||
| − | + | Changing the internal IP addresses of a TMG requires to reset the Unit's role (Standlone/Primary/Secondary). Once the role is reset, the Web Portal will show steps to re-configure the Unit's Role, and at the same time select the internal Subnets to use. | |
To reset the Unit's role: | To reset the Unit's role: | ||
Revision as of 10:20, 7 January 2015
This article explains how to modify the internal subnets of a TMG800, TMG3200 or TMG7800 Unit.
Click here for more information on internal subnets of TMG Units
1. Resetting the Unit role
Note: If your Unit was just shipped, it does not yet has it's "role" configured, and you can skip to step 2 below.
Changing the internal IP addresses of a TMG requires to reset the Unit's role (Standlone/Primary/Secondary). Once the role is reset, the Web Portal will show steps to re-configure the Unit's Role, and at the same time select the internal Subnets to use.
To reset the Unit's role:
Log into the Unit's Web Portal
Click the "Status" tab
Click on the serial number of the Unit
Select Action "Reset Host Role"
Click "Apply Action"
Refresh the web page until role selection appears
(this can take a minute...)
Click "Continue", answer the questions
Click on "change internal subnets"
Change subnets as required, click "continue"
Note: You may not see some of the options in the above screenshot. Only options available for current product are shown on this page.
Click "continue" and "confirm"
Confirmation pages will appear, continue or confirm if you're satisfied with your choices.
Wait until configuration is completed
(This can take a few minutes...)
Login page will be back
