Toolpack:Creating an M3UA Configuration SGP C
From TBwiki
(Difference between revisions)
(→List of Parameters: Added advanced parameter links) |
(→List of Parameters) |
||
| Line 32: | Line 32: | ||
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
| + | <br> | ||
Advanced Parameters | Advanced Parameters | ||
* [[Parameter: M3UA: Only one hardware unit is active|Only one hardware unit is active]] | * [[Parameter: M3UA: Only one hardware unit is active|Only one hardware unit is active]] | ||
Revision as of 10:20, 23 June 2015
Applies to version(s): v2.7.
To set up your M3UA system as a Signaling Gateway Process (SGP), you must first create a new M3UA configuration.
In this configuration the the SIGTRAN M3UA is an extension of the MTP3 layer. This system is typically set up between Signaling Gateway Process (SGP) and Application Server Process .
To create an M3UA SGP configuration:
1- Click M3UA in the navigation panel:
2- Configure the M3UA service for SGP:
- Enter a name for the configuration
- Select Signaling Gateway Process (SGP) as the node type
- Click Create
3- Verify that the "M3ua Cfg was successfully created" message appears
