Parameter: Call Control
From TBwiki
(Difference between revisions)
(minor corrections) |
|||
| (One intermediate revision by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter | + | The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter has the following values: |
| − | * Incoming | + | * Incoming: Circuits are always controlled by the remote end. Calls will not be sent to these circuits. |
| − | * Outgoing | + | * Outgoing: Circuits are always controlled by TMG. Inbound calls from these circuits will be rejected. |
| − | * Bothway | + | * Bothway: Circuits work for both inbound and outbound calls. |
| − | * Controlled | + | * Controlled: Same as Incoming |
| − | * Controlling | + | * Controlling: Same as Outgoing |
[[Category:Parameters]] | [[Category:Parameters]] | ||
Latest revision as of 13:12, 21 December 2015
The Call Control parameter is used to set a call control method for ISUP CIC groups. Values for this parameter are selected from a drop-down list. The Call Control parameter has the following values:
- Incoming: Circuits are always controlled by the remote end. Calls will not be sent to these circuits.
- Outgoing: Circuits are always controlled by TMG. Inbound calls from these circuits will be rejected.
- Bothway: Circuits work for both inbound and outbound calls.
- Controlled: Same as Incoming
- Controlling: Same as Outgoing
