Toolpack:Modifying ISUP Stack for SPIROU B
From TBwiki
(Difference between revisions)
m |
m |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): v2.8, v2.9, v2.10''''' === | + | === '''''Applies to version(s): v2.8, v2.9, v2.10, v3.0''''' === |
{{DISPLAYTITLE:Modifying ISUP Stack for SPIROU}} | {{DISPLAYTITLE:Modifying ISUP Stack for SPIROU}} | ||
Revision as of 13:50, 29 November 2017
Applies to version(s): v2.8, v2.9, v2.10, v3.0
This article assumes that SS7 ISUP is configured.
Note that if you want to eventually validate SPIROU configuration, you will need to repeat these steps for all the ISUP stacks in your current configuration..
1- Select ISUP from the navigation panel
2- Select the ISUP stack you wishto configure.
3- Expand the Advanced Parameters section and set the following parameters:
- No confusion must be selected
- Click Save
4- Verify that the "IsupStack was successfully updated" message is displayed
