Toolpack:Creating an M3UA User Part (SGP) C
From TBwiki
(Difference between revisions)
m |
m |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): | + | === '''''Applies to version(s): 2.9, 2.10, 3.0, 3.2''''' === |
{{DISPLAYTITLE:Creating an M3UA User Part (SGP)}} | {{DISPLAYTITLE:Creating an M3UA User Part (SGP)}} | ||
After you create an M3UA network, you must create a new M3UA user part. | After you create an M3UA network, you must create a new M3UA user part. | ||
Latest revision as of 12:44, 21 August 2020
Applies to version(s): 2.9, 2.10, 3.0, 3.2
After you create an M3UA network, you must create a new M3UA user part.
To create an M3UA user part:
1- Click M3UA in the navigation panel:
2- Select an M3ua Network:
3- Click Create New M3ua Userpart in the M3UA network configuration window
3- Configure the new M3UA user part:
- For a system set up on a Signaling Gateway, you need to connect this entity to a MTP3 network: Select an MTP3 network
- Note: the MTP3 network field is only shown for a SGP.
- Click Create
4- Verify that the "M3ua Userpart was successfully created" message appears
Path
/configurations/@[configuration_name]/m3ua_stacks/@[m3ua_name]/m3ua_networks/@[m3ua_network]/m3ua_userparts/@[m3ua_userpart]
Parameters (text)
/configurations/@[configuration_name]/m3ua_stacks/@[m3ua_name]/m3ua_networks/@[m3ua_network]/m3ua_userparts/@[m3ua_userpart] mtp3_network = "NONE" name = "@[m3ua_userpart]" prim_timer = "3 minutes
Parameters (json)
{
"mtp3_network" : "NONE",
"name" : "@[m3ua_userpart]",
"prim_timer" : "3 minutes"
}
List of Parameters
Advanced Parameters
