Toolpack:Reset HostRole A
From TBwiki
(Difference between revisions)
(Created page with "=== '''''Applies to version v2.8''''' === {{DISPLAYTITLE:Resetting the Host Role}} If you need to change the internal IP addresses of a gateway, you must reset the units' hos...") |
|||
| (12 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | == | + | {| class="wikitable" |
| + | |- | ||
| + | |rowspan="3"|This article applies to: | ||
| + | |'''Product''' | ||
| + | |'''Version''' | ||
| + | |- | ||
| + | |Tmedia | ||
| + | |2.8, 2.9, 2.10, 3.0, 3.2 | ||
| + | |- | ||
| + | |SBC | ||
| + | |3.0, 3.1 | ||
| + | |} | ||
{{DISPLAYTITLE:Resetting the Host Role}} | {{DISPLAYTITLE:Resetting the Host Role}} | ||
| − | + | If you need to change internal IP addresses, you must reset the host role settings of the unit. | |
| − | If you need to change | + | |
'''To reset the host role, do the following:''' | '''To reset the host role, do the following:''' | ||
| − | 1- | + | 1- Click '''Hosts''' in the navigation panel. |
[[Image:HostRoleReset_0_A.png]] | [[Image:HostRoleReset_0_A.png]] | ||
| − | 2- Select | + | 2- Select the serial number of the unit. |
[[Image:HostRoleReset_1_A.png]] | [[Image:HostRoleReset_1_A.png]] | ||
| − | 3- | + | 3- Click the '''Status''' tab. |
| − | + | ||
[[Image:HostRoleReset_2_A.png]] | [[Image:HostRoleReset_2_A.png]] | ||
| − | + | 4- Select '''Reset Host Role''' | |
| − | + | * Click '''Apply Action''' | |
[[Image:HostRoleReset_3_A.png]] | [[Image:HostRoleReset_3_A.png]] | ||
| − | + | 5- The Web Portal setup wizard is displayed. (You may need to refresh your web page to see this) | |
| − | + | ||
[[Image:HostRoleReset_4_A.png]] | [[Image:HostRoleReset_4_A.png]] | ||
Latest revision as of 09:11, 11 November 2020
| This article applies to: | Product | Version |
| Tmedia | 2.8, 2.9, 2.10, 3.0, 3.2 | |
| SBC | 3.0, 3.1 |
If you need to change internal IP addresses, you must reset the host role settings of the unit.
To reset the host role, do the following:
1- Click Hosts in the navigation panel.
2- Select the serial number of the unit.
3- Click the Status tab.
4- Select Reset Host Role
- Click Apply Action
5- The Web Portal setup wizard is displayed. (You may need to refresh your web page to see this)
