Toolpack:Starting Continuity Check ISUP A
From TBwiki
(Difference between revisions)
Nicole Tan (Talk | contribs) (Removed v2.6 from "- →Applies to version(s): v2.6, v2.7.: ") |
|||
| (2 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | |||
{{DISPLAYTITLE:Starting Manual Continuity Check}} | {{DISPLAYTITLE:Starting Manual Continuity Check}} | ||
| + | {| class="wikitable" | ||
| + | |- | ||
| + | |rowspan="3"|This article applies to: | ||
| + | |'''Product''' | ||
| + | |'''Version''' | ||
| + | |- | ||
| + | |Tmedia | ||
| + | |2.7, 2.8, 2.9, 2.10, 3.0, 3.2 | ||
| + | |} | ||
Note: the option might not be available if the resources required for the test (tone generation and detection) are not available. | Note: the option might not be available if the resources required for the test (tone generation and detection) are not available. | ||
| Line 7: | Line 15: | ||
1- Select '''SS7->ISUP''' from the navigation panel | 1- Select '''SS7->ISUP''' from the navigation panel | ||
| − | 2- Click | + | 2- Click the '''Status''' tab and click on the appropriate ISUP Stack |
| − | 3- Click | + | 3- Click the '''Interfaces''' tab and select the appropriate ISUP Interface |
| − | 4- Click | + | 4- Click the '''Circuit Groups''' tab and select the appropriate Circuit Group |
'''If you want to start a continuity check on all circuits of a circuit group:''' | '''If you want to start a continuity check on all circuits of a circuit group:''' | ||
*Select '''Yes''' for'''Start continuity check''' and click on '''Apply states''' | *Select '''Yes''' for'''Start continuity check''' and click on '''Apply states''' | ||
| − | *Click | + | *Click '''Now''' to refresh the status and see the result of the test. Some of the following stats should be modified: |
**Total ccr success cnt | **Total ccr success cnt | ||
**Total ccr fail cnt | **Total ccr fail cnt | ||
Latest revision as of 14:16, 1 December 2020
| This article applies to: | Product | Version |
| Tmedia | 2.7, 2.8, 2.9, 2.10, 3.0, 3.2 |
Note: the option might not be available if the resources required for the test (tone generation and detection) are not available.
1- Select SS7->ISUP from the navigation panel
2- Click the Status tab and click on the appropriate ISUP Stack
3- Click the Interfaces tab and select the appropriate ISUP Interface
4- Click the Circuit Groups tab and select the appropriate Circuit Group
If you want to start a continuity check on all circuits of a circuit group:
- Select Yes forStart continuity check and click on Apply states
- Click Now to refresh the status and see the result of the test. Some of the following stats should be modified:
- Total ccr success cnt
- Total ccr fail cnt
- Last ccr unknown cnt
- Last ccr in progress cnt
- Last ccr success cnt
- Last ccr fail cnt
- Last ccr error cnt
If you want to start a continuity check on a specific circuit:
- Click on the Circuits tab and select the circuit in the Cic column.
- Select Yes forStart continuity check and click on Apply states
- Click on Now to refresh the status and see the result of the test. Some of the following stats should be modified:
- Nb outgoing ccr success
- Nb outgoing ccr fail
- Last ccr result
