Toolpack:Creating the SCTP Configuration A
From TBwiki
(Difference between revisions)
| Line 14: | Line 14: | ||
** [[RAW IP|RAW_IP]] | ** [[RAW IP|RAW_IP]] | ||
** [[UDP IP|UDP]] | ** [[UDP IP|UDP]] | ||
| − | * Click ''' | + | * Click '''Create''' |
| − | [[Image:Toolpack_v2. | + | [[Image:Toolpack_v2.5_Creating_SCTP.png]] |
| − | 3- Verify that the '''Sctp Cfg was successfully | + | 3- Verify that the '''Sctp Cfg was successfully created''' message appears |
| − | [[Image:Toolpack_v2. | + | [[Image:Toolpack_v2.5_SCTP_Created.png]] |
Revision as of 12:27, 30 June 2010
Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence transport of messages.
To edit your system's SCTP configuration:
1- Select SCTP from the navigation panel
2- Configure the SCTP service
- Make sure the box labeled Enabled is checked
- Enter a name for the SCTP service
- Select an appropriate service type:
- Click Create
3- Verify that the Sctp Cfg was successfully created message appears
