Toolpack:Creating an SCCP LSAP A
From TBwiki
(Difference between revisions)
| Line 1: | Line 1: | ||
| + | Now that you have created an SCCP user part, you must create a new SCCP lower service access point (LSAP). | ||
| + | |||
| + | Creating an [[Toolpack:Create_an_SCCP_LSAP|LSAP]] tells the [[SCCP]] protocol layer about a collection of [[SS7]] nodes that are accessible through [[MTP3 Layer|MTP3]]. | ||
| + | |||
To Create an SCCP LSAP: | To Create an SCCP LSAP: | ||
| + | |||
1- Click '''Create New SCCP LSAP''' in the SCCP network configuration window | 1- Click '''Create New SCCP LSAP''' in the SCCP network configuration window | ||
| Line 12: | Line 17: | ||
[[Image:Toolpack_v2.5_Creating_SCCP_LSAP.png]] | [[Image:Toolpack_v2.5_Creating_SCCP_LSAP.png]] | ||
| − | 3- Verify that the '''SccpLsap was successfully created''' message appears | + | 3- Verify that the '''"SccpLsap was successfully created"''' message appears |
[[Image:Toolpack_v2.5_SCCP_LSAP_Created.png]] | [[Image:Toolpack_v2.5_SCCP_LSAP_Created.png]] | ||
Revision as of 11:51, 15 July 2010
Now that you have created an SCCP user part, you must create a new SCCP lower service access point (LSAP).
Creating an LSAP tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.
To Create an SCCP LSAP:
1- Click Create New SCCP LSAP in the SCCP network configuration window
2- Configure the new SCCP LSAP:
- Enter a name for the LSAP
- Click Save
3- Verify that the "SccpLsap was successfully created" message appears
