Toolpack:Creating an SCCP LSAP A
From TBwiki
(Difference between revisions)
| (4 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| + | === '''''Applies to version(s): v2.5, v2.6, 2.7''''' === | ||
| + | {{DISPLAYTITLE:Creating an SCCP LSAP}} | ||
Now that you have created an [[SCCP]] network, you must create a new SCCP lower service access point ([[LSAP]]). | Now that you have created an [[SCCP]] network, you must create a new SCCP lower service access point ([[LSAP]]). | ||
| Line 21: | Line 23: | ||
[[Image:Toolpack_v2.5_SCCP_LSAP_Created.png]] | [[Image:Toolpack_v2.5_SCCP_LSAP_Created.png]] | ||
| + | |||
| + | 4- '''Next Step:''' [[Toolpack_v2.5:Creating_an_SCCP_Route|Create an SCCP Route]] | ||
==List of Parameters== | ==List of Parameters== | ||
Latest revision as of 10:30, 15 July 2013
Applies to version(s): v2.5, v2.6, 2.7
Now that you have created an SCCP network, you must create a new SCCP lower service access point (LSAP).
Creating an LSAP tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.
To Create an SCCP LSAP:
1- Click Create New SCCP LSAP in the SCCP network configuration window
2- Configure the new SCCP LSAP:
- Enter a Name for the LSAP
- Click Save
3- Verify that the "SccpLsap was successfully created" message appears
4- Next Step: Create an SCCP Route
List of Parameters
| Previous | Next |
|---|---|
| Create an SCCP Userpart | Create an SCCP Route |
