Configure Fax Passthrough C
From TBwiki
(Difference between revisions)
Clod Patry (Talk | contribs) (create the page C (for 2.7)) |
Clod Patry (Talk | contribs) (adding header) |
||
| Line 1: | Line 1: | ||
| + | === '''''Applies to version(s): v2.7.''''' === | ||
| + | {{DISPLAYTITLE:Configure Fax Passthrough}} | ||
| + | |||
To enable passthrough, follow these steps: | To enable passthrough, follow these steps: | ||
<pre> | <pre> | ||
Latest revision as of 09:07, 18 June 2012
Applies to version(s): v2.7.
To enable passthrough, follow these steps:
1. Make sure "Enable Fax/Modem Relay" is enabled. 2. Make sure "Detection Mode" is Standard. 3. Make sure "Relay Mode" is Passthrough. 4. Make sure "Enable switching to FAX relay upon CNG tone" is checked. 5. Make sure "Detection type" is "Silence Suppression off" 6. Make sure the Codec is the same as the remote end.
