Toolpack:Configuring RADIUS A
From TBwiki
(Difference between revisions)
(2.5 only, fixed title) |
(add support of previous version) |
||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): v2.5.''''' === | + | === '''''Applies to version(s): v2.3, v2.4, v2.5.''''' === |
{{DISPLAYTITLE:Toolpack: Configuring RADIUS}} | {{DISPLAYTITLE:Toolpack: Configuring RADIUS}} | ||
This page describes how to configure a RADIUS server for accounting in Toolpack v2.5 or earlier. | This page describes how to configure a RADIUS server for accounting in Toolpack v2.5 or earlier. | ||
Latest revision as of 09:04, 31 October 2012
Applies to version(s): v2.3, v2.4, v2.5.
This page describes how to configure a RADIUS server for accounting in Toolpack v2.5 or earlier.
1- Select Gateway -> Configurations from the navigation panel.
2- Verify that the box Use CDR behavior is checked.
3- Configure the CDR behavior in the CDR Options section:
- Select Radius CDR in the CDR Mode combo box.
- In the Radius server parameters section, set the Radius server address and port and Server secret fields.
- Click Save to save your changes.
4- Verify that the Gateway configuration was successfully updated. message appears.
