Modify Fax Relay Profile B
From TBwiki
(Difference between revisions)
m |
|||
| (2 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | === '''''Applies to | + | === '''''Applies to versions: 2.6, v2.7''''' === |
{{DISPLAYTITLE:Modifying FAX Relay Profile Settings}} | {{DISPLAYTITLE:Modifying FAX Relay Profile Settings}} | ||
| Line 15: | Line 15: | ||
2- Modify settings as required. | 2- Modify settings as required. | ||
| − | [[ | + | [[File:fax_modem_relay_nse.png]] |
| + | |||
| + | 3- To configure NSE, check the '''Use NSE''' checkbox. | ||
| + | |||
| + | '''NOTE:''' | ||
| + | |||
| + | If NSE exchange is possible (negociated in the SDP), the switch to passthrough will happen in the RTP stream and no longer wiil occur with a SIP re-INVITE. This implementation of NSE currently only supports a switch to passthrough, which means that you can have NSE packets switching to T.38. | ||
* Click '''Save''' | * Click '''Save''' | ||
| Line 41: | Line 47: | ||
* [[Parameter: Fax Modem Pass-Through Parameters: Jitter Buffer Depth| Fax Modem Pass-Through Parameters: Jitter Buffer Depth]] | * [[Parameter: Fax Modem Pass-Through Parameters: Jitter Buffer Depth| Fax Modem Pass-Through Parameters: Jitter Buffer Depth]] | ||
* [[Parameter: Fax Modem Pass-Through Parameters: Use NSE| Fax Modem Pass-Through Parameters: Use NSE]] | * [[Parameter: Fax Modem Pass-Through Parameters: Use NSE| Fax Modem Pass-Through Parameters: Use NSE]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Latest revision as of 10:58, 6 November 2014
Applies to versions: 2.6, v2.7
To configure FAX Relay settings, do the following:
1- Click Fax Relay in the Editing Profile window, to display the customizable options.
2- Modify settings as required.
3- To configure NSE, check the Use NSE checkbox.
NOTE:
If NSE exchange is possible (negociated in the SDP), the switch to passthrough will happen in the RTP stream and no longer wiil occur with a SIP re-INVITE. This implementation of NSE currently only supports a switch to passthrough, which means that you can have NSE packets switching to T.38.
- Click Save
List of Parameters
Fax/Modem Relay
- Fax Modem Relay:Enable Fax/Modem Relay
- Fax Modem Relay: Detection Mode
- Fax Modem Relay: Relay Mode
- Fax Modem Relay: Modem vs. Fax distinction timeout
- Fax Modem Relay: Fax/Modem tones detection duration
- Fax Modem Relay: Enable early Fax/Modem tone detection
- Fax Modem Relay: Enable switching to FAX relay upon CNG tone
T.38 Parameters
- T.38 Parameters: Use V.34
- T.38 Parameters: Maximum Bit Rate
- T.38 Parameters: Fill Bit Removal
- T.38 Parameters: Redundancy Count
- T.38 Parameters: Transmission level (-1dBm unit)
Fax/Modem Pass-through Parameters
