Toolpack:Creating the M2PA Configuration B
From TBwiki
(Difference between revisions)
(Created page with "=== '''''Applies to version(s): v2.7.''''' === {{DISPLAYTITLE:Creating the SCTP Configuration}} Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensure...") |
|||
| (5 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
=== '''''Applies to version(s): v2.7.''''' === | === '''''Applies to version(s): v2.7.''''' === | ||
| − | {{DISPLAYTITLE:Creating the | + | {{DISPLAYTITLE:Creating the M2PA Configuration}} |
| − | + | ||
| − | To | + | To create an M2PA configuration: |
| − | 1- Select ''' | + | 1- Select '''M2PA''' from the navigation panel |
[[Image:M2pa_0.png]] | [[Image:M2pa_0.png]] | ||
| − | 2- Configure the | + | 2- Configure the M2PA service |
* Make sure the box labelled '''Enabled''' is '''checked''' | * Make sure the box labelled '''Enabled''' is '''checked''' | ||
| − | * Enter a '''name''' for the | + | * Enter a '''name''' for the M2PA service |
| − | + | ||
| − | + | ||
| − | + | ||
* Click '''Create''' | * Click '''Create''' | ||
| − | [[Image: | + | [[Image:CreateM2pa_1_a.png]] |
| − | + | ||
| − | + | ||
| − | + | 3- Verify that the '''"M2ua Cfg was successfully created"''' message appears | |
| + | [[Image:CreateM2pa_2.png]] | ||
==List of Parameter== | ==List of Parameter== | ||
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
| − | |||
Latest revision as of 11:57, 18 September 2014
Applies to version(s): v2.7.
To create an M2PA configuration:
1- Select M2PA from the navigation panel
2- Configure the M2PA service
- Make sure the box labelled Enabled is checked
- Enter a name for the M2PA service
- Click Create
3- Verify that the "M2ua Cfg was successfully created" message appears
