Toolpack:Creating an ISUP Network B
m (→Applies to version(s): v2.8) |
(→List of Parameters: correction to the name of displayed parameter) |
||
| (3 intermediate revisions by one user not shown) | |||
| Line 4: | Line 4: | ||
The ISUP network communicates with the ISUP protocol layer about the collection of SS7 nodes that are accessible through MTP3 or M3UA. | The ISUP network communicates with the ISUP protocol layer about the collection of SS7 nodes that are accessible through MTP3 or M3UA. | ||
| − | Based upon your system configuration, one or more ISUP networks | + | Based upon your system configuration, you must create one or more ISUP networks. Repeat this procedure for as many networks as you require. |
| Line 10: | Line 10: | ||
To create an ISUP network: | To create an ISUP network: | ||
| − | 1- Click '''ISUP''' in the navigation | + | |
| + | 1- Click '''ISUP''' in the navigation panel. | ||
[[Image:CreateIsupStack_0.png]] | [[Image:CreateIsupStack_0.png]] | ||
| Line 45: | Line 46: | ||
* '''Depending on the type chosen:''' | * '''Depending on the type chosen:''' | ||
** [[Parameter: MTP3 Network|MTP3 Network]] | ** [[Parameter: MTP3 Network|MTP3 Network]] | ||
| − | ** [[Parameter: M3UA Network|M3UA | + | ** [[Parameter: M3UA Network|M3UA Userpart]] |
Latest revision as of 10:29, 16 September 2015
Applies to version(s): v2.8
After you create an ISUP stack, you must create a ISUP network.
The ISUP network communicates with the ISUP protocol layer about the collection of SS7 nodes that are accessible through MTP3 or M3UA. Based upon your system configuration, you must create one or more ISUP networks. Repeat this procedure for as many networks as you require.
NOTE: An ISUP network can be used by multiple ISUP interfaces even if they are members of different ISUP userpart; for example, to support multiple switch variants for a single SS7 network.
To create an ISUP network:
1- Click ISUP in the navigation panel.
2- Select the ISUP stack
3- Click "Create New ISUP Network" in the ISUP stack configuration window
4- Configure the new ISUP network:
- Enter a name for the network
- Select MTP3 or M3UA as the type of network to bind
- Select a MTP3 network or a M3UA network
- Click Create
5- Verify that the "IsupNetwork was successfully created" message is displayed.
List of Parameters
- Name
- Type of Network to Bind
- Depending on the type chosen:
