Toolpack:Creating a NAP (SIGTRAN) C
From TBwiki
(Difference between revisions)
(New article) |
(→List of Parameters: Added call-rate limiting parameter links) |
||
| (4 intermediate revisions by one user not shown) | |||
| Line 40: | Line 40: | ||
| − | '''The following | + | '''The following information is displayed:''' |
[[Image:CreateIsupNap_5.png]] | [[Image:CreateIsupNap_5.png]] | ||
| Line 46: | Line 46: | ||
*Select a value for [[Parameter:_Channel_Usage|'''Channel Usage''']], to avoid call collision | *Select a value for [[Parameter:_Channel_Usage|'''Channel Usage''']], to avoid call collision | ||
*Click '''Save''' | *Click '''Save''' | ||
| + | |||
6- Verify that the '''"NAP was successfully updated"''' message appears | 6- Verify that the '''"NAP was successfully updated"''' message appears | ||
| Line 51: | Line 52: | ||
[[Image:CreateIsupNap_6.png]] | [[Image:CreateIsupNap_6.png]] | ||
| − | <br> | + | <br> |
== List of Parameters == | == List of Parameters == | ||
| Line 58: | Line 59: | ||
*[[Parameter: Default Profile|Default Profile]] | *[[Parameter: Default Profile|Default Profile]] | ||
*[[Parameter: Channel Usage|Channel Usage]] | *[[Parameter: Channel Usage|Channel Usage]] | ||
| + | |||
| + | |||
| + | '''Advanced Parameters-Call rate limiting''' | ||
| + | *[[Parameter: Maximum calls per second|Maximum calls per second]] | ||
| + | *[[Parameter: Maximum call burst|Maximum call burst]] | ||
| + | *[[Parameter: Maximum simultaneous incoming calls|Maximum simultaneous incoming calls]] | ||
| + | *[[Parameter: Maximum simultaneous outgoing calls|Maximum simultaneous outgoing calls]] | ||
| + | *[[Parameter: Maximum simultaneous total calls|Maximum simultaneous total calls]] | ||
| + | *[[Parameter: Processing delay low threshold|Processing delay low threshold]] | ||
| + | *[[Parameter: Processing delay high threshold|Processing delay high threshold]] | ||
Latest revision as of 10:48, 28 September 2015
Applies to version(s): v2.8.
A Network Access Point (NAP) represents the entry point to another network or destination peer.
After you have created an ISUP CIC group, you must create a network access point.
To create a network access point (NAP):
1- Click NAPs in the navigation panel
2- Click Create New NAP
3- Configure the new NAP:
- Enter a name for the NAP
- Select a user-created profile, if not, select default
- Click Create
4- Verify that the NAP was successfully created message appears
5- Associate an ISUP interface with the NAP:
- Select an interface (the newly-created ISUP CIC group)
- Click the "<<" button to add the interface to the list
The following information is displayed:
- Select a value for Channel Usage, to avoid call collision
- Click Save
6- Verify that the "NAP was successfully updated" message appears
List of Parameters
Advanced Parameters-Call rate limiting
