Toolpack:Creating the M2PA Configuration c
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.8.) |
(→Applies to version(s): v2.8.) |
||
| (One intermediate revision by one user not shown) | |||
| Line 3: | Line 3: | ||
| − | To create | + | To create an M2PA configuration: |
1- Select '''M2PA''' from the navigation panel | 1- Select '''M2PA''' from the navigation panel | ||
| Line 26: | Line 26: | ||
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
| − | |||
Latest revision as of 09:46, 18 September 2014
Applies to version(s): v2.8.
To create an M2PA configuration:
1- Select M2PA from the navigation panel
2- Configure the M2PA service
- Make sure the box labelled Enabled is checked
- Enter a name for the M2PA service
- Click Create
3- Verify that the "M2pa Cfg was successfully created" message appears
