Toolpack:Creating an SCCP LSAP B
From TBwiki
(Difference between revisions)
(New 2.8 article) |
(→List of Parameters: Added Max Msg Length parameter) |
||
| (3 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | === '''''Applies to version(s): v2. | + | === '''''Applies to version(s): v2.8''''' === |
{{DISPLAYTITLE:Creating an SCCP LSAP}} | {{DISPLAYTITLE:Creating an SCCP LSAP}} | ||
| − | + | After you create an [[SCCP]] network, you must create a new SCCP lower service access point ([[LSAP]]). | |
Creating an [[Toolpack:Create_an_SCCP_LSAP|LSAP]] tells the [[SCCP]] protocol layer about a collection of [[SS7]] nodes that are accessible through [[MTP3 Layer|MTP3]]. | Creating an [[Toolpack:Create_an_SCCP_LSAP|LSAP]] tells the [[SCCP]] protocol layer about a collection of [[SS7]] nodes that are accessible through [[MTP3 Layer|MTP3]]. | ||
| Line 22: | Line 22: | ||
| − | [[Image: | + | [[Image:Create_SCCP_LSAP_0.png]] |
| Line 28: | Line 28: | ||
* Enter a [[Parameter: Name|Name]] for the LSAP | * Enter a [[Parameter: Name|Name]] for the LSAP | ||
| − | * Click ''' | + | * Click '''Create''' |
| − | [[Image: | + | [[Image:Create_SCCP_LSAP_1.png]] |
5- Verify that the '''"SccpLsap was successfully created"''' message appears | 5- Verify that the '''"SccpLsap was successfully created"''' message appears | ||
| − | [[Image: | + | |
| + | [[Image:Create_SCCP_LSAP_2.png]] | ||
| Line 41: | Line 42: | ||
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
| + | |||
| + | '''Advanced Parameters''' | ||
| + | * [[Parameter: Max Msg Length|Max Msg Length]] | ||
Latest revision as of 13:57, 30 September 2015
Applies to version(s): v2.8
After you create an SCCP network, you must create a new SCCP lower service access point (LSAP).
Creating an LSAP tells the SCCP protocol layer about a collection of SS7 nodes that are accessible through MTP3.
To Create an SCCP LSAP:
1- Select SCCP from the navigation panel
2- Select an SCCP Network
3- Click Create New SCCP LSAP in the SCCP network configuration window
4- Configure the new SCCP LSAP:
- Enter a Name for the LSAP
- Click Create
5- Verify that the "SccpLsap was successfully created" message appears
List of Parameters
Advanced Parameters
