Enabling Local NAT Traversal B
From TBwiki
(Difference between revisions)
(2.8 article) |
|||
| (One intermediate revision by one user not shown) | |||
| Line 10: | Line 10: | ||
| − | 2- Click '''Create New | + | 2- Click '''Create New NAT Traversal''' |
| − | + | ||
| + | [[Image:EnableLocalNatTraversal_1.png]] | ||
| + | |||
| + | |||
| + | 3- Enter a meaningful name. | ||
* Choose a Local Method. | * Choose a Local Method. | ||
* If necessary, provide an extra parameter. | * If necessary, provide an extra parameter. | ||
* Click '''Create''' | * Click '''Create''' | ||
| − | + | [[Image:EnableLocalNatTraversal_2.png]] | |
| − | [[Image: | + | |
| − | + | ||
Once the NAT configuration is completed, it must be associated with a NAP. | Once the NAT configuration is completed, it must be associated with a NAP. | ||
| + | |||
3- Select '''NAPs''' from the navigation panel | 3- Select '''NAPs''' from the navigation panel | ||
| − | [[Image: | + | [[Image:EnableLocalNatTraversal_3.png]] |
4- Select a SIP NAP from the '''Network Access Point''' list | 4- Select a SIP NAP from the '''Network Access Point''' list | ||
| − | [[Image: | + | [[Image:EnableLocalNatTraversal_4.png]] |
| Line 37: | Line 40: | ||
* Click '''Save''' | * Click '''Save''' | ||
| − | [[Image: | + | [[Image:EnableLocalNatTraversal_5.png]] |
Latest revision as of 14:15, 12 November 2014
Applies to version: v2.8.
To enable Local NAT Traversal:
1- Select NATs from the navigation panel.
2- Click Create New NAT Traversal
3- Enter a meaningful name.
- Choose a Local Method.
- If necessary, provide an extra parameter.
- Click Create
Once the NAT configuration is completed, it must be associated with a NAP.
3- Select NAPs from the navigation panel
4- Select a SIP NAP from the Network Access Point list
5- In the Network Address Translation section:
- Choose the desired "Local Method". The select box will contain the same name as the Local NAT configuration, that you provided in step #2.
- Click Save
The following describes the 2 Local NAT Traversal Methods:
No NAT
This method is used if you are not behind a NAT. This is the default value.
Force Public IP
This method will set some of the SIP Headers and SDP fields with the IP address that you set.
