Toolpack:Adding an TMS C
From TBwiki
(Difference between revisions)
(→List of Parameters: Target state link) |
(→List of Parameters: Added links to TMS advanced parameters) |
||
| Line 49: | Line 49: | ||
* [[Parameter: Description|Description]] | * [[Parameter: Description|Description]] | ||
* [[Parameter: Target State|Target State]] | * [[Parameter: Target State|Target State]] | ||
| + | |||
| + | Advanced Parameters | ||
| + | * [[Parameter: Enable management port redundancy|Enable management port redundancy]] | ||
| + | * [[Parameter: Enable HTTP access|Enable HTTP access]] | ||
| + | * [[Parameter: Enable Telnet access|Enable Telnet access]] | ||
Latest revision as of 12:50, 9 June 2015
Applies to version v2.8
When you receive a new system, at least one hardware configuration will have been set in the Toolpack application server, by default. To add a TMS hardware device to your system, you must use the Tmedia Web Portal.
To add one or more additional hardware devices to the Toolpack system configuration, their serial numbers must be registered with the Toolpack application server.
To add a hardware device:
1- Click Hardware Units in the navigation panel
2- Click Create New Unit, to add a new hardware device
3- Enter a name for the hardware device
- Enter the serial number of the new hardware device (filling in the Serial Number field will cause auto-completion of the field to occur).
- Select the appropriate hardware device from the Type field. (In this case select TMS)
- Enter the location in which the hardware device is installed.
- Enter a meaningful description for the use or purpose of the hardware device.
- Select Enabled from the Target State field.
- Click Create
4- Verify that the newly added hardware device appears in the TMS Units list.
List of Parameters
Advanced Parameters
