Toolpack:Creating an M3UA User Part (SGP) B
From TBwiki
(Difference between revisions)
(→Applies to version(s): v2.8) |
(→Advanced Parameters) |
||
| (2 intermediate revisions by one user not shown) | |||
| Line 32: | Line 32: | ||
4- Verify that the '''"M3ua Userpart was successfully created"''' message appears | 4- Verify that the '''"M3ua Userpart was successfully created"''' message appears | ||
| − | [[Image: | + | [[Image:Create_M3UAUserPart_2_SGP.png]] |
==List of Parameters== | ==List of Parameters== | ||
* [[Parameter: Name|Name]] | * [[Parameter: Name|Name]] | ||
| + | |||
| + | |||
| + | '''Advanced Parameters''' | ||
| + | * [[Parameter: MTP3 Primitive Timer|MTP3 Primitive Timer]] | ||
Latest revision as of 14:04, 26 June 2015
Applies to version(s): v2.8
After you create an M3UA network, you must create a new M3UA user part.
To create an M3UA user part:
1- Click M3UA in the navigation panel:
2- Select an M3ua Network:
3- Click Create New M3ua Userpart in the M3UA network configuration window
3- Configure the new M3UA user part:
- For a system set up on a Signaling Gateway, you need to connect this entity to a MTP3 network: Select an MTP3 network
- Note: the MTP3 network field is only shown for a SGP.
- Click Create
4- Verify that the "M3ua Userpart was successfully created" message appears
List of Parameters
Advanced Parameters
