|
|
| (13 intermediate revisions by 4 users not shown) |
| Line 1: |
Line 1: |
| − | [[Image:Diagram-mtp3-layer.jpg|thumb|300px|Diagram of the MTP3 layer]] | + | #REDIRECT[[MTP3]] |
| − | The MTP3 layer provides message routing between signaling points in an [[SS7]] network. This layer routes traffic away from failed links and signaling points and controls traffic when congestion occurs. The MTP3 layer contains a Userpart that represents a specific protocol variant.
| + | |
| − | | + | |
| − | A conceptual illustration of the MTP3 layer is provided on the right.
| + | |
| − | | + | |
| − | | + | |
| − | == TelcoBridges and MTP3 ==
| + | |
| − | TelcoBridges supports the MTP3 layer in its SS7 signaling stack. It also provides the following functionality:
| + | |
| − | *Up to 64 [[OPC|OPCs]] per system
| + | |
| − | *Up to 64 [[Linkset|linksets]] per system
| + | |
| − | *Point code sharing by multiple devices with external [[Toolpack]] control
| + | |
| − | | + | |
| − | | + | |
| − | === Supported MTP3 variants ===
| + | |
| − | *ANSI (used for ANSI88 and ANSI92)
| + | |
| − | *ANSI96 (used for ANSI96 and Telcordia)
| + | |
| − | *ITU (used for ITU88, ITU92, ITU97, Q767, Singapore and ETSI)
| + | |
| − | *China, GF001-9001
| + | |
| − | | + | |
| − | == Related actions ==
| + | |
| − | *[[Toolpack:Create an MTP3 Configuration|Create an MTP3 Configuration]]
| + | |
| − | *[[Toolpack:Create an MTP3 Network|Create an MTP3 Network]]
| + | |
| − | **[[Toolpack:Create an MTP3 Point Code|Create an MTP3 Point Code]]
| + | |
| − | **[[Toolpack:Create an MTP3 Linkset|Create an MTP3 Linkset]]
| + | |
| − | **[[Toolpack:Create an MTP3 Route|Create an MTP3 Route]]
| + | |
| − | *[[Toolpack:Status Menus:SS7 MTP3|Verify status of SS7 MTP3 elements]]
| + | |
| − | | + | |
| − | | + | |
| − | == References ==
| + | |
| − | *[http://en.wikipedia.org/wiki/Message_Transfer_Part Wikipedia article]
| + | |
| − | | + | |
| − | | + | |
| − | [[Category:Glossary]]
| + | |
